Advertisement
Count Up Timer – will display brewing time
1-Cup – short press will run for 15 seconds – long press will start programming
2-Cup – short press will run for 25 seconds – long press will start programming
Power – short press will turn machine ON – long press will turn machine OFF
Hot Water – short press will run for 45 seconds
Steam – short press will start heating the machine for frothing - Steam indicator will
start to flash – once illuminated steaming can begin – long press to go back to
espresso brewing
Important: The machine is programmed to dispense espresso for 15 seconds when
using the 1-Cup indicator and 25 seconds when using the 2-Cup indicator. It is possible
to stop the flow of espresso by pressing the 1-Cup indicator or the 2-Cup indicator again.
Both the 1-Cup and the 2-Cup indicators can be programmed.
5. Turning OFF
We suggest turning OFF the machine when not in use. If you forget to turn OFF the
machine, it will automatically shut off after 25 minutes of inactivity. Press and hold the
Power indicator for 3 seconds to turn OFF the machine. The product indicator lights will
turn OFF and the Power indicator will stay illuminated. NOTE: When not in use, remove
the portafilter. This will extend the life of the seal around the brew head.
6. Warming Internal Components and Cups
For the best results, we recommend that you preheat the portafilter and sieve before
ground coffee is added and prewarm the cups. When the machine is powered ON, cups
can be warmed on the cup warming tray for 10-15 minutes prior to brewing.
a) Press the illuminated Power indicator to turn the machine ON. Make sure steam
control knob is in the closed position (Fig. 4). The product indicator lights will slowly
flash while the machine heats up.
b) Insert the portafilter, without any coffee. Align the portafilter at the inscription
"INSERT", push the portafilter up and turn it firmly to the right towards "LOCK"
until it feels tight.
c) Once the required temperature has been reached the product indicator lights will
stop flashing and all indicators will be illuminated. Place cup(s) under the
portafilter spouts.
d) Press the 1-Cup or 2-Cup indicator to start brewing. Hot water will be pumped
through the filter into the cups.
e) When the water flow stops and the cups are filled with hot water, remove them
from the machine and empty into the sink. Unlock the portafilter by turning the
handle to the left to release the portafilter from the machine. Dry portafilter before
adding ground coffee.
8
Advertisement
