LG 42PQ20 Training Manual page 62

P101 Y - SUS to Control PWB P111 Plug Information
P101 Y - SUS to Control PWB P111 Plug Information
Voltage Measurements for the Y SUS Board
These connector pins are too close to read without
possible damage to the PWB
Actually a 30 Pin Connector "Measurements can be made
on the Control PWB
Y-SUS Board B+ checks for the P101 connector.
FS201
5V to run the Control Board.
Also sent to the Z-SUS Board.
Routed through the Control Board.
Leaves the Control Board on P101 pins 10.
Standby: 0V Run: 5V Diode Check: 1.1V
FS501
15V to run the Z-SUS Board.
Routed through the Control Board.
Leaves the Control Board on P101 pins 11 and 12.
Standby: 0V Run: 15V Diode Check: 0.78V
62 January 2009 Plasma 42PQ20