Cursor Menu - Furuno FAR21x7 & BB FAR28x7 Operator's Manual BB FAR28x7 Operator's Manual

1. RADAR OPERATION
1.6

Cursor Menu

Functions which require the use of the cursor, such
as EBL offset and zoom, may be activated directly
from the guidance box or from the CURSOR menu,
either method with the cursor inside the effective
display area. Below is the procedure for choosing a
cursor-related function from the CURSOR menu. In
later sections only the procedure for selection from
the guidance box is given.
1. Roll the trackball to place the cursor inside the
effective display area.
2. Roll the wheel to show "TARGET DATA & ACQ /
CURSOR MENU" in the guidance box.
3. Push the right button to show the CURSOR
menu.
4. Roll the wheel to choose "2" and then push the
wheel or the left button.
5. Roll the wheel to choose function desired and then push the wheel or the left
button.
Note: For operation from the keyboard, you may press the [2] key to choose a
function in top-to-bottom order or the [8] key to choose in reverse order.
Cursor Menu item
TARGET DATA & ACQ
TARGET CANCEL
ARP TGT DATA & ACQ
TARGET TRACK ON
TARGET TRACK OFF
REF MARK
EBL OFFSET
OFF CENTER
ZOOM
MARK DELETE
CHART ALIGN
1-10
ARP: Acquires ARP target; displays data for chosen ARP target.
AIS: Activates sleeping AIS target; display data for chosen AIS
target.
ARP: Cancels tracking on chosen ARP target.
AIS: Sleeps chosen AIS target.
Acquires chosen echo as ARP target.
Turns ARP target track on. (A, B, C and W types)
Turns ARP target track off. (A, B, C and W types)
Inscribes reference mark, for target-based speed input.
Offsets EBL to measure range and bearing between two targets.
Shifts screen center to chosen location.
Zooms chosen location.
Deletes chosen mark (plotter mark, origin mark or waypoint
mark).
Aligns chart with radar picture.
[CURSOR MENU]
↓
2
TARGET DATA & ACQ/
TARGET CANCEL/
ARP TGT DATA & ACQ/
TARGET TRACK ON*/
TARGET TRACK OFF*/
REF MARK/
EBL OFFSET/
OFFCENTER/
ZOOM/
MARK DELETE/
CHART ALIGN/
↑
8
* Not available on IMO type
Description