Erasing All Marks And Lines - Furuno FAR21x7 & BB FAR28x7 Operator's Manual BB FAR28x7 Operator's Manual

5.11.2

Erasing all marks and lines

To erase all plotter marks and lines from the memory, follow the procedure
below.
1. Roll the trackball to choose the MENU box at the right side of the screen and
then push the left button.
2. Roll the wheel to choose 5 PLOTTER and then push the wheel or the left
button.
3. Roll the wheel to choose 8 [DATA ERASE] and then push the wheel or the
left button.
1 BACK
2 OWN TRACK
3 TARGET TRACK*
4 MARK ALL ERASE
5 WPT ALL ERASE
6 NAV LINE ALL ERASE
4. Roll the wheel to choose 4 MARK ALL ERASE.
5. Roll the wheel to choose YES and then push the wheel or the left button to
erase all plotter-related marks and lines.
6. Push the right button three times to close the menu.
[DATA ERASE]
RED/GRN//BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
RED/GRN//BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
NO/YES
NO/YES
DATA ERASE menu
5. VIDEO PLOTTER OPERATION
* Not available on IMO type
5-19