Table of Contents
Advertisement
(3) Installing the thread stand
❶
❷
(4) Installing the operation panel base
❷
5) The sewing machine stops once more at the
1) Assemble thread stand unit ❶ .
2) Insert it in the hole located in the rear of the
Fix operation panel base ❶ at the dotting punch
section on the machine table with wood screw ❷ .
❶
❶
- 5 -
final stage of lowering for the safety. Support
the periphery ribs of machine bed with your
left hand, hold the grip of hinge stopper sec-
tion with your right hand to release the lock
and slowly lower the sewing machine follow-
ing the description of step 3).
DANGER :
Take care to prevent pinching of hands
and fingers between the sewing machine
and the bottom cover. In particular,
never lower the sewing machine holding
parts other than the bed rib with two or
more workers, since doing so can cause
pinching o f hands, fingers and arms
leading to a serious injury.
machine table, and tighten locknut ❷ to fix
the thread stand.
When the ceiling wiring i s possible, pass
the power cord through the spool rest
rod.
Protection vinyl is coated on the surface
of the operation panel. Remove it.
Advertisement
Table of Contents
