Position Of The Presser Foot And The Needle Entry Point; Adjusting The Knife Dropping Position - JUKI MEB-3200C Instruction Manual

(6) Position of the presser foot and the needle entry point

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start
of the sewing machine.
A
❷
0 to 0.5 mm

(7) Adjusting the knife dropping position

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start
of the sewing machine.
❶
❷
❸
B
❸
❶
❸
❹
❸
- 57 -
Adjust the clearance between the presser
foot and the holding plate to 0 to 0.5 mm.
Loosen two setscrews ❶ in the presser arm base
and the adjust the clearance. Then fix the presser
arm in place.
Moving presser arm ❷ in the direction
A will reduce the clearance between the
presser foot and the outside needle entry
point.
* The front or rear inclination can be adjusted
with presser arm setscrew ❸ .
● Upper knife type
Loosen setscrew ❶ in the cloth cutting knife
installing base, adjust cloth cutting knife in-
stalling base ❷ to the left or right. Then fix the
base.
● Lower knife type
Loosen setscrews ❸ in the knife base and
adjust knife base ❹ to the left or right. Then
fix the knife base.