Punch In/Out Using The Footswitch - Fostex LIVE RECORDING MIXER LR16 Owner's Manual

(7) At the punch in point, press the [RECORD]
key while holding down the [PLAY] key.
Track 3 is punched in (switches from
playback to recording).
<Note>: To perform punch in, do not for-
get to hold down the [PLAY] key when
pressing the [RECORD] key.
(8) At the punch out point, press only the
[PLAY] key.
Track 3 is punched out (switches from
recording to playback).
<Note>: You cannot perform punch in/
out successively without stopping the re-
corder. To perform more than one punch
in/out operation, stop the recorder each
time you finish punch in/out.
(9) Press the [STOP] key to stop the recorder,
and locate the recorder back to the punch
in position.
<Memo>: By pressing the [STOP] key on
the mixer section, the recorder automati-
cally skips to the beginning of the project
(ABS 0) and stops.
(10) Press the [PLAY] key to play back the
project to check the result.
If you are not satisfied with the result, roll
back the previous project data before punch
in/out (see page 76 for details).
Model LR16 [Recorder functions / Recording/playback]
Punch in/out using a footswitch
You can perform punch in/out using a
footswitch connected to the [FOOT SW] jack on
the rear panel of the main unit.
The following procedure example describes how
to perform punch in/out to track 3 of the project
whose tracks 1 through 8 have been recorded.
It is assumed that you have completed source
connection, level adjustment, mixer settings, etc.
<Note>: To use a footswitch for punch in/out,
the "Foot SW" item in the "System" menu of the
MENU mode must be set to "P I/O". Though it is
set to "P I/O" by default, if it is set to an option
other than "P I/O", change it to "P I/O" (see page
77 for details).
P (+4dBu) EFF SEND (-2dBu)
ST MIX OUT (-10dBV) MIDI OUT
USB
Press down the
footswitch (punch in).
Playback
(1) Connect an unlatched footswitch to the
[FOOT SW] jack.
<Note>:
Do not use a footswitch which is
not the unlatched type. Connecting an
improper footswitch may cause malfunc-
tion.
(2) Turn off the [NEW PROJECT] key in the
recorder section.
(3) Turn on the [REC TRACK SELECT] key for
track 3.
(4) Set the [SOURCE] switches on mixer
channels 1 through 8 to "TRK" (
The playback signals of tracks 1 through 8
are routed to the mixer input channels.
55
INPUT
AUX SEND (-2dBu) INSERT INSERT INSERT INSERT INSERT INSERT
FOOT SW CONTROLLER PANEL LOCK
LOCK
PHANTOM POWER
Footswitch
Press down the footswitch again
(punch out).
Playback
Recording
I
).