Fostex LIVE RECORDING MIXER LR16 Owner's Manual page 56

Model LR16 [Recorder functions / Recording/playback]
(5) Set the [ST] switches on mixer channels 1
through 8 to "ON" (
<Note>: Make sure that all the [SOLO]
switches on the mixer channel to "OFF"
and the [MONITOR SELECT] switch is set
to "ST".
(6) Raise the [STEREO] fader to the "0"
position.
(7) Locate the recorder to the point earlier than
the punch-in point and press the [PLAY]
key to start playback.
<Hint>: To perform punch in smoothly,
it is recommended to play your instru-
ment along with the playback sound.
<Memo>:
Use channel faders 1 through
8 to adjust the playback signal levels on
tracks 1 through 8 individually, and use
the [MONITOR] and [PHONES] controls
to adjust the total monitor level.
<Note>: You cannot perform punch in/
out successively without stopping the
recorder. To perform more than one
punch in/out operation, stop the re-
corder each time you finish punch in/
out.
(10) Press the [STOP] key to stop the recorder,
and locate the recorder back to the punch
in position.
<Memo>: By pressing the [STOP] key on
the mixer section, the recorder automati-
cally skips to the beginning of the project
(ABS 0) and stops.
(11) Press the [PLAY] key to play back the
project to check the result.
If you are not satisfied with the result, roll
back the previous project data before punch
in/out (see page 67 for details).
).
56