Integrating The Control Unit And Main Unit - Fostex LIVE RECORDING MIXER LR16 Owner's Manual

Follow the procedure below to integrate the control unit and main unit.
<Note>:
Work on a flat and stable surface. It is recommended to put the units on a soft
cloth (or blanket) to protect the units.
<Necessary items>
• Phillips-head screwdriver (which matches the fixing screws for rack mounting)
• The supplied CAT-5 cable
(1) Remove the rack mount angles attached to the side panels of each unit.
The removed rack mount angles and fixing screws are used in step (3) below, so be
careful not to loose them.
Rack mount angle
Rack mount angle
(2) Connect the [ETHER] connector of the control unit and the [CONTROLLER] connector
of the main unit using the supplied CAT-5 cable.
The cable should run through the cable guides fixed near the connectors of the both
units (see below).
<Note>:
cable while the LR16 is powered on.
When you connect or disconnect a CAT-5 cable,
make sure that the LR16 is powered off.
CONTROLLER
<Note>:

Integrating the control unit and main unit

Do not connect or disconnect a CAT-5
Main unit
Insert the connector of the cable firmly in the correct direction.
Model LR16 [Before using the unit]
Main unit
Control unit
Cable guide
Control unit
15
Rack mount angle
Rack mount angle