Install A Simple-Swap Drive And The Drive Cage (Bay 3) - Lenovo ThinkSystem ST50 V2 Setup Manual

Install a simple-swap drive and the drive cage (bay 3)

Follow this procedure to install a simple-swap drive and the drive cage into bay 3.
Remove a simple-swap drive (bay 3)
Follow this procedure to remove a simple-swap drive from bay 3.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read "Safety inspection checklist" on page 43 and "Installation Guidelines" on page 41 to ensure that you
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page 99.
• If the server is in a rack, remove it from the rack. See "Remove the server from the rails" on page 47.
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1. Make preparation for this task.
a. Remove the server cover, see "Remove the server cover" on page 49.
Note: The heat sink and processor could be very hot. To avoid burning yourself, wait for a few
minutes after turning off the server before you remove the server cover.
b. If applicable, remove the optical drive, see "Remove an optical drive" on page 71.
c. Remove the optical drive cage from the chassis, see "Remove the optical drive cage" on page
75.
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
Chapter 3
.
Server hardware setup
65