Back Panel Connections - EverFocus EDSR100H Instruction Manual

3. Back Panel Connections

6
5
POWER
Power in: The main power in.
1
AUDIO
2
Audio IN : Audio input for recording.
Audio OUT : These two audio outputs can be set to "Enable" or "Disable" in Setup Menu.
Audio IN
Operation of SW1 :
When in recording or standby mode,
the out of SW1 is connected to Audio IN.
When in playback mode the out of SW1 is
connected to SW2 Audio.
When Audio Out is enabled and machine is in Recording or Standby mode, the Audio IN is loop-through to Audio Out
connector.
When Audio Out is enabled and machine is in Playback mode then the Audio Out playback audio.
Back Panel Connections
10
3
MUX MAIN
MONITOR IN
2
4
The operation of audio out is as follows:
SW2
OFF / Mute
Playback Audio
8
7
9 1
( Internal circuit )
SW1
A
Operation of SW2 :
When Playback Audio is enabled then the output
of SW2 will be connected to Playback Audio.
When Playback Audio is disabled then there is no
audio output (MUTE).
5
Audio OUT