Injury - Delta RS830 Instruction Manual

CHANgINg THE POSITION OF THE BEVEL CLAMP HANdLE
To reposition the bevel clamp handle:
To reduce the risk of injury, turn unit off and disconnect machine from power source before installing and
removing accessories, before adjusting or changing set-ups or when making repairs. An accidental start-up can cause injury.
1. Loosen the bevel clamp handle (A) Fig. 52, release the
bevel index release knob (B), and turn the motor (C) to
the vertical position.
NOTE: If the blade guard contacts the table surface, raise
the track arm.
2. Loosen the bevel clamp handle (A) Fig. 52 several
turns until the hex head of the screw (D) can be
pushed out of hex-shaped recess in yoke.
3. Turn the screw (D) Fig. 52 one or two flats of the hex
head in the direction the handle needs to be turned.
Push it back into hex-shaped recess in yoke.
4. Tighten the bevel clamp handle (A) Fig. 52.
NOTE: The screw is left-hand thread - turn the clamp
handle counter-clockwise to tighten.
CHANgINg THE POSITION OF THE YOKE CLAMP HANdLE
To reposition the yoke clamp handle (A) Fig. 53:
To reduce the risk of injury, turn unit off and
disconnect machine from power source before installing
and removing accessories, before adjusting or changing
set-ups or when making repairs. An accidental start-up can
cause injury.
1 Remove retaining ring (B) Fig. 53.
2. Reposition yoke clamp handle (A) Fig. 53 on hex clamp
nut.
3. Replace retaining ring (B) Fig. 53
POSITIVE STOP YOKE INdEX
The yoke index lever (A) Fig. 54 activates a positive stop that positions the cuttinghead in the cross-cut or rip position. To rotate
the cuttinghead, release the yoke clamp handle, press up or down on yoke index lever (A) to release the positive stop, and
rotate the cuttinghead to either the #1 in-rip or #2 out-rip or #3 cross-cut positions. Release the yoke index lever (A) Fig. 53 and
the cuttinghead will automatically index at each of the three positions.
POSITIVE STOP BEVEL INdEX
The bevel index knob (A) Fig. 55 provides a positive stop when positioning the saw blade at 0°, 45°, and 90° left, and 90° right
on the bevel scale (C). To change the angle of the saw blade, loosen the bevel clamp handle (B), pull out bevel index knob (A),
and tilt the saw blade and motor. For the 0°, 45°, and 90° left, and 90° right positions, release the bevel index knob (A) and the
saw blade will index at each of these positions. Tighten the bevel clamp handle (B). For saw blade angles between positive
stops, set the blade at the desired angle on bevel scale (C) and tighten the bevel clamp handle (B) Fig. 55.
A
Fig. 54
22
d
C
A
B
C
B
A
Fig. 52
Fig. 53
B
A
Fig. 55