Setting The Clock - Emerson PD5802 Owner's Manual

OPERATING INSTRUCTIONS
• Make sure that the FM Antenna is fully extended.
• Make sure that you have installed batteries in the remote control.
• Make sure that the AC power cord is connected to an outlet that is always
"live". Do not connect to an outlet that is controlled by a wall switch.

SETTING THE CLOCK

When the main unit is connected to the AC outlet for the first time the STANDBY
LED indicator on the front panel lights and "0:00" appears on the display.
Note: Do not turn the main unit power ' On' . The clock can only be set while the
main unit power is ' Off' .
1.) Press and hold the PROGRAM/TIME ADJ button
on the front panel or the remote control. "24H"
flashes on display. Press SKIP
to select between "24H" 24 hour or "12H" 12 hour
modes.
2.) Press the PROGRAM/TIME ADJ button on the
front panel or the remote control. Just the Hour
digits will continue flashing.
3.) Press the F.SKIP / R.SKIP buttons on the top panel of the main unit or
buttons on the remote control to set the display to the correct hour, AM or PM.
4.) Press the PROGRAM/TIME ADJ button again.
The Minute digits will begin flashing.
5.) Press the F.SKIP/R.SKIP buttons on the top panel of the main unit or
buttons on the remote control to set the display to the correct minutes.
6.) Press the PROGRAM/TIME ADJ button once
more. The time display stops flashing and the
clock begins to run.
PD5802_ib031803.p65
/ buttons
11
11
/
/
18/3/2003, 11:06