Table of Contents
Advertisement
Step 8 - Managing User Codes (cont.)
The Pre-delivery outputs are defined as follow:
Alarm Type
Panic Alarm
Burglary Alarm
Close Programmable Output Event
Open Programmable Output Event
Fire Alarm
Medical Alarm
A relay must be used when any device requiring a current greater than 50mA is connected to the programmable output.
The programmable output is a current sink circuit with a maximum output voltage of 13.6VDC and a maximum output
current of 50mA. Programmable outputs are primarily connected to trigger external device inputs but not to drive
external devices. The Watchguard Relay Board (P/N: WGAPARB) must be used for connecting, LEDs, sirens, bus-wired
peripherals, etc.
There are many locations and values for setting the programmable outputs. Please read Installer Manual for more
detailed information.
Optional Settings
Skip steps 9 to 11 if not using a dialer.
Step 9 - Setting Account Codes (Location 61 - Partition 1)
Input a 4-digit account number for the control centre.
Enter 1479* 61* [ACCOUNT NUMBER]* #
Step 10 - Setting Phone Numbers (Location 51-54)
Up to 4 telephone numbers can be stored. Installers can press # to exit INSTALLER MENU at anytime without having
the need to set up all 4 phone numbers.
Enter 1479* 51* [TELEPHONE NUMBER 1]*
52* [TELEPHONE NUMBER 2]*
53* [TELEPHONE NUMBER 3]*
54* [TELEPHONE NUMBER 4]*
# (exit INSTALLER MENU)
10
Output
Output 1 - Pulse high for 2 seconds
Output 2 - Pulse high for 2 seconds
Output 3 - Set High
Output 3 - Set Low
Output 4 - Pulse high for 2 seconds
Output 5 - Pulse high for 2 seconds
WGAP864 Alarm Panel Quick Installation Guide - Version: WGA-Q321
Advertisement
Table of Contents
