Setup & Usage
Step 1: Registering a Keypad
After all wiring has been completed, power up the control panel. If a keypad is un-registered, the second line of the
LCD will show "Unreg". You need to register the keypad first.
1. Press the [#] key.
2. Wait for about 2 seconds.
3. An ID will be assigned to the keypad the registered ID number will be shown on the LCD.
4. Register all "Un-reg" keypads.
Step 2 - Setting Date and Time
Must do this BEFORE proceeding to Step 4 because the keypad keeps reminding you to set up date and time.
1. Press and hold the * button to enter the "User Menu"
2. When you see:
User Menu
Master Code + *
Enter: 1835* 40* [hhmm]* 41* [ddmmyy]* #
Where hh=hour in 24-hour format (00-23), mm=minute (00-59),
ddmmyy=day (01-31), month (01-12) and year (01-12) respectively
Note: hh, mm, dd, mm, yy must be two-digit, for example, 4/8/2018 should be inputted as: 040818.
Step 3 - Setting Daylight Saving Information (Location 25-31)
For Queensland, the Northern Territory and Western Australia: (Disable Daylight saving)
Enter: 1479* 25* 0* 28* 0* #
Explanation: This sequence set location 25 to 0 and location 28 to 0.
1479* is used to enter INSTALLER MENU, # at the end is used to exit the INSTALLER MENU.
For New South Wales, Victoria, South Australia, Tasmania, and the Australian Capital Territory:
Enter: 1479* 25* 10* 26* 7* 27* 1* 28* 4* 29* 7* 30* 1* 31* 60* #
Explanation: See table below.
1479* is used to enter INSTALLER MENU, # at the end is used to exit the INSTALLER MENU.
Location
25
Daylight Start Month
26
Daylight Start Day
27
Daylight Start Week
28
Daylight End Month
29
Daylight End Day
30
Daylight End Week
31
Daylight Offset
The LCD will show "Updating Panel Please Wait..." and exit the installer menu.
6
Field
Value
10 (October)
7 (Sunday)
1 (First week)
4 (April)
7 (Sunday)
1 (First week)
60 (60 minutes)
WGAP864 Alarm Panel Quick Installation Guide - Version: WGA-Q321