Inserting The Tape Cartridge Into The 1/4-Shelf Disk/Tape Sru - Northern Telecom DNC-50 Installation Manual

Inserting the Tape Cartridge into the 1/4-shelf Disk/Tape SRU

Load the tape cartridge into the slot as follows:
(1) Set the SAFE pointer on the tape as required:
•
If you are downloading data from the system hard disk to tape, set the
pointer away from SAFE.
•
If you are uploading data from the tape to the system hard disk, set the
pointer toward SAFE.
(2) Open the door of the appropriate cabinet or rack and locate the cartridge tape
drive.
(3) Hold the tape cartridge with the metal side facing toward the left, and the keyed
slot on the top, as shown in Figure 13-4.
(4) Guide the tape cartridge into the slot of the SRU, pushing forward so that the
cartridge rests partially in place.
(5) Push downward the knob located above the slot. This locks the cartridge into
place. If done correctly, the drive operates to find the beginning of the tape.
Insertion is complete.
Loading/Removing the Tape Cartridge (Cartridge SRU) 117
Practice 450-1011-201