Power Saver Mode; System; 2-Way Remote - Directed Electronics 50.7X Owner's Manual

Directed electronics security and remote start owner's guide

Hide thumbs Also See for 50.7X:

Table of Contents

Power saver mode

Your system will automatically enter Power Saver Mode while armed or

in Valet Mode, after a period of time in which no operation has been

performed. This lowers the current draw on the vehicle's battery. Power

Saver Mode takes over under the following conditions:

Power Saver when the system is armed:

After the system has been

armed for 24 hours the LED will flash at half its normal rate, decreasing

the system's current draw.

Power Saver in Valet Mode:

When the system enters Valet Mode the

Status LED on the Responder LE control center illuminates steadily. If the

vehicle is not used (ignition is not turned on) for a one hour period while

the system is in Valet Mode, the status LED will shut off. If the system

remains in Valet Mode, the LED will come back on the next time the

ignition is turned on and then back off.

Your Responder LC 2way remote control has a feature called remote

power save mode. When programmed ON under remote options, the

remote will conserve power by disabling the paging function if unused

for more than 72 hours. Pressing any button on the remote will restore

the paging function.

The default setting is ON. See Remote control programming section of

this guide or ask your dealer for details on how to program.

Table of Contents