Table of Contents
Advertisement
User guide
CANMAX400 Standalone
Revision: 16-Nov-09
Manual transmission
If the vehicle has manual transmission the proper steps must be followed before leaving the parked vehicle or the remote
start feature is disabled.
1. Put the transmission in neutral.
2. Press on the vehicle's foot brake.
3. Apply the emergency brake.
4. Release the vehicle's foot brake.
Pressing the brake again after this step will disable the remote start feature.
5. Within 15 seconds activate the remote start from the remote.
6. The parking lights will flash confirming that the remote start is active.
7. Turn off the ignition (the car should stay running when key is turned off).
8. Exit the vehicle.
9. Arm the alarm (the vehicle should shut off when arming the system).
You can now remote start the vehicle. If a door is opened or if the alarm is triggered before the next remote start activation
the system will not remote start.
To drive your vehicle after it has been remote started:
1. Get in without stepping on the brake.
2. Insert the ignition key and turn it to the ON position.
3. Now, step on the brake.
The remote control will play the remote start shutdown tone. You have now taken direct control from the remote start
system.
Power save mode
System
Your system will automatically enter Power Saver Mode while armed after a period of time in which no operation has been
performed. This lowers the current draw on the vehicle's battery. Power Saver Mode takes over under the following
conditions:
Power Saver when the system is armed: After the system has been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
2-way remote control
Your 2-way remote control has a feature called remote power save mode. When programmed ON under remote options,
the remote will conserve power by disabling the paging function if unused for more than 72 hours. Pressing any button on
the remote will restore the paging function.
The default setting is ON. See Remote control programming section of this guide or ask your dealer for details on how to
program.
10
© 2009 Directed Electronics, Inc. All rights reserved.
Advertisement
Table of Contents
