Toyotomi ENSO Series User Manual page 53

AIR PURIFIER
5. Follow the same procedure for the rear panel.
6. When the panels are installed correctly on the front and the rear side, you
will hear a distinctive sound. If the protrusion at the bottom of the front and
back panel does not fi t properly, the device will not work.
7. DO NOT operate the device without the fi lters on.
3.Install the Pre-fi lter:
After you install the Enhanced composite fi lter 2 in 1
HEPA13/Active Carbon, install the Pre-fi lter by putting in
the holes from the bottom to the top side. The front side
of the prefi lter has two bulge outwards. Put its lower part
into the bottom slot and bend it gently into the upper slot.
4. Install the panel:
Reinstall the front panel. Push the front panel parallel
along the upper and lower edges. Install it carefully
in order for the teeth to lean the upper and the lower
side of the device. Make sure that on the right and the
left side of the device the panel is installed correctly
Then press carefully down & up in the middle of the
panel until it's installed correctly on the edges, then
the panel is installed correctly.
53
GB