Table of Contents
Advertisement
AMD NVMe/SATA RAID Quick Start Guide for
Windows Operating Systems
3.5
Enable RAID for FP6 Processors
Note: Raid configuration support is restricted to Raid0 level only. The steps to configure a system to
RAID mentioned here are specific to AMD NDA BIOS based off the Insyde BIOS.
1. Power-on the system.
2. Press ESC to enter the System BIOS setup page.
3. In the BIOS setup:
a. Select AMD PBS tab, then press Enter.
b. Set the NVMe RAID Mode to Enabled, then press Enter.
4. Save (F10) the settings and restart the system.
14
Pre-Installation Steps
56268 Rev. 1.05 November 2021
Chapter 3
Advertisement
Table of Contents
