Enable Raid For 300/400/500 Amd Socket Am4-Compatible Processors - AMD NVMe/SATA RAID Quick Start Manual

[Public]
56268 Rev. 1.05 November 2021
3.2
Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS
based off the AMI BIOS. The steps for other BIOS Vendors are different.
1. Power-on the system.
2. Press ESC to enter the System BIOS setup page.
3. In the BIOS setup:
a. Select the Advanced tab.
b. Select CSM Configuration, then press Enter.
c. Set CSM Support to Enabled, then press Enter.
d. Set Boot option filter to UEFI only, then press Enter.
e. Set Storage to UEFI, then press Enter.
4. In the BIOS setup:
a. Select the Advanced tab.
b. Select AMD-CBS, then press Enter.
c. Select FCH Common Options, then press Enter.
d. Select SATA Configuration Options, then press Enter.
e. Set SATA Enable to Enabled, then press Enter.
f. Set SATA Mode to RAID, then press Enter.
5. In the BIOS setup:
a. Select the Advanced tab.
b. Select AMD-CBS, then press Enter.
c. Select 300/400/500 Chipset Common Options, then press Enter.
d. Select 300/400/500 Chipset SATA Configuration Options, then press Enter.
e. Set SATA Mode to RAID, then press Enter.
6. In the BIOS setup:
a. Select the Advanced tab.
b. Select AMD-PBS, then press Enter.
c. Set NVMe RAID Mode to Enabled, then press Enter.
7. Save (F4) the settings and restart the system.
Chapter 3
Enable RAID for 300/400/500 AMD Socket
AM4-Compatible Processors
AMD NVMe/SATA RAID Quick Start Guide for
Pre-Installation Steps
Windows Operating Systems
11