Power Module Component Locations - Trane CH530 Installation, Operation And Maintenance Manual

Drive and Cabinet
Power Module Component
Locations
Frame 3 Units (405, 600 A)
The main power module components for a Frame 3 unit
are listed below. Each numbered item corresponds to a
number in Figure 2 or Figure 3.
1. Wire Harness Assembly, Power Supply, Logic
2. Current Feedback Device, 1000 A
3. Terminal Block, 2-position
4. 80 W Power Supply Assembly
5. Cable Assembly, 40-pin, 0.050 in Pitch, Flex Film
6. Cable Assembly, 30-pin, 0.050 in Pitch, Flex Film
7. Wire Harness Assembly, Power Supply, Upper Gate
8. Inverter Power Interface Assembly
9. Wire Harness Assembly, Power Supply, Lower Gate
10. Insulation Sheet
11. DPI Communications Interface
12. Rectifier Power Interface Assembly
13. Wire Harness Assembly, Gate Driver
14. Wire Harness Assembly, Current Feedback Device
15. Wire Harness Assembly, Line Sync.
16. Wire Harness Assembly, DC Bus Bleeder Resistors
17. Cable Assembly, 20-pin, 0.050-in. Pitch, Flex Film
18. RS-485 Communications Assembly (RECOMM)
19. Internal Fan
20. Connector, Terminal Block, 32-pin
21. ac Line I/O Assembly
22. Rectifier Control Assembly
23. Inverter Control Assembly
24. Standard I/O Board (optional)
25. Synchronization Cable
10 AFDK-SVU01C-EN