Sony HDW-700A Maintenance Manual page 63

Reading the Reference File Data from the Setup Card (Steps 2 and 3 of Fig. 5-3.)
During the file storing, read the reference files which have been stored in the setup card at the same time.
The reference files in the camera can also be changed.
Set the setting menus as follows.
After the data of the setup card is read to the camera, STANDARD will be executed automatically.
n
When the power is just turned on, the reference files stored in the setup card will not be read. This file
will only be read when READ is executed at the setting menu.
Initializing All File Items Using Setting Menus (Step 4 of Fig. 5-3.)
Set the setting menus as follows.
[FILE] → [REFERENCE|FILE] → [CLEAR|FILE]
Initializing Only Specified Items Using Setting Menus (Step 4 of Fig. 5-3.)
References files for specified items can be initialized using setting menus.
(1) Set the initialization function to ON.
(2) Set the setting menus as follows.
[FILE] → [REFERENCE|FILE] → [10|SEC|CLEAR] → [ON]
(3) Move to the page containing the items to be cleared from the reference files in the PAINT or MAIN-
TENANCE menu.
(4) Adjust "→" to the item to be erased using the MIC/MENU knob, and keep pressing this knob about
10 seconds at "?" state until "REF CLEAR " is displayed. About 3 seconds later, "DATA CLEAR"
will be displayed at the bottom most line. The "REF CLEAR" is displayed about 10 seconds later,
and the data will be initialized to 0.
m
. Only items which can be numerically set can be initialized. ON/OFF settings and selected items cannot
be erased.
. The 10 SEC CLEAR function must always be set to OFF when the power is turned ON.
Current paint data
Output to hardware
HDW-700AE MMP1
Setup card
Step 1 Step 3
Step 1
Reference File
Step 2
Fig. 5-3. Operating Procedure for Reference Files
Reference File
Step 4
factory-set value
(Initial value 0)
5-4. Registering Reference Files
5-5