Sony HDW-700A Maintenance Manual page 30

2-5. Cassette Compart∑ment Aseembly Removal and Installation
Installation
1. Adjust the position of the joint arm so that the clear-
ance between the white roller of the joint arm and the
edge of the mechanism deck assembly is 0.5 mm, as
shown.
Roller (White)
0.5 mm
2. Raise the white lock roller of the cassette compartment
in the direction of the arrow to bring it into the raised
position.
Lock roller (White)
2-12
Mechanism deck
assembly end
Joint arm
3. Move the cam plate (A) on the right side of the
cassette compartment in the direction of the arrow with
your fingers until it stops.
4. Hold the cassette compartment as shown, and attach
the two cassette guide pins in the chassis so that they
go inside the round holes of the stage.
At the same time, make sure that the white roller of the
joint arm of step 1 stays inside the notch of the cam
plate (A) on the right side.
5. Push the lever of the cassette compartment and make
sure that the stage moves up and down smoothly. If
not, check from step 1 again.
6. Attach the cassette compartment with the three screws.
* The frame of the unit is not shown in the figure.
M1.4 x 2.5
Lever
Round hole
of stage
Cassette
guide pin
Notch
Roller (white) of step 1
Joint arm
Cassette guide pin
Cam plate (A)
M1.4 x 2.5
Stage
M1.4 x 2.5
Cam plate (A)
notch
Eject arm
roller (White)
HDW-700AE MMP1