Table of Contents
Advertisement
Adjustable Hydraulic Scissor Lift With Castors
Agitation Devices for White Ink Containers
> White ink needs agitation EVERY TIME before refilling the tank.
> White ink containers MUST BE FLIPPED 180° in your stock room once a week.
We suggest two different types of machines to agitate the white ink containers before filling the ink
tank on the printer. These tools will help you to mix the ink homogeneously. Remember that a bulk
ink container of 18 liters is quite heavy and weighs around 44 pounds. Once the non-agitated ink
goes inside the tubes of the printer, it is not possible to remove it and shake it again.
If white ink is not agitated thoroughly, white prints will look faded and gray.
Two Suggestions for Agitation Devices
An agitation device must be used, such as a Santint G48 Gyroscopic Paint Mixer for high ink
usage or a fitness vibration plate for low to intermediate ink usage. It is best to pick the agitation
device based on how often you will use an 18L container of white ink. You must have a device
available to use even if neither of these examples are purchased.
Santint G48
Gyroscopic
Paint Mixer
Insert the white ink
container inside the
two doors and let
the mixer spin for
5 minutes.
> Inspect white ink containers for sediment periodically during agitation. Test, as time listed is only recommended.
6
This tool will help to move the bulk ink containers into
position to fill the ink tanks cleanly and easily.
To use the adjustable hydraulic scissor lift to help refill an
ink tank, adjust the lift to the appropriate height and guide
the faucet on the ink container directly over the opening
of the ink tank before opening the spout (see photo to the
left). This will keep the ink from spilling on the floor.
BLUEFIN
Fitness 3D
Vibration
Plate
Just drop the white
ink container on
top of it and let the
vibrating plate run
for up to 2 hours.
Advertisement
Table of Contents
