Thermal Mode - Pentair STA-RITE INTELLIFLO3 VSF User Manual

Thermal Mode

Pump Dashboard ˃ Device Settings ˃ Advanced Settings >
Thermal Mode
Thermal Mode is intended to help protect the pump during freezing
or near-freezing conditions.
Note: Do not depend on this feature for freeze protection of the
entire filtration system and pool.
Certain situations could cause the pump to sense a different
temperature than actual air temperature. Your automation system air
temperature sensor should be used to sense actual temperature. For
example, if the pump is located indoors, the temperature of the room
does not indicate the outdoor temperature.
Note: The pump does NOT sense water temperature.
1- Enable/Disable: Enable or disable Thermal Mode protection.
2− Temperature Set Point: Set the temperature at which the
Thermal Mode program will initiate.
3− Speed/Flow Display: Determines whether the Speed/Flow
setting below is displayed as a percentage of max speed or in
GPM.
4− Speed/Flow Setting: Set the Speed% or GPM the pump will
run when Thermal Mode is triggered.
5− Save: Saves edits to Thermal Mode settings.
INTELLIFLO3™ VSF and INTELLIPRO3™ VSF Variable Speed and Flow Pump User' s Guide
2
3
4
5
FIGURE 12
9
1