q
B
r
e
w
q
11–15 mm
w
r
4 mm
A
t
q
10
11. Check Spring Stroke
The amount of the needle thread supplied by the check
spring should be 11–15 mm.
z
Thread the machine up to the thread guide
lower the presser foot.
Lower the needle bar to the lowest position.
Hold the thread end and mark the point
x
thread beside the thread guide.
NOTE:
There should be no slack in the thread.
c
Pull the thread gently to the left until it stops (the
check spring
e
went full stroke).
Measure the length of thread drawn out.
v
b
Loosen the setscrew
t
guide
to adjust the stroke.
• If the length is too long, turn the guide in the direction A.
• If the length is too short, turn the guide in the direction B.
Tighten the setscrew
n
12. Pre-tension Dial
The standard position of the pre-tension dial is as follows:
q
The screw head
sinks 4 mm below the dial face.
on the
w
r
and move the tension dial
.
r
q
and