GE Advantium 120 Technical Service Manual page 40

To replace the latch boards:
1. Place the oven in a partially removed position.
(See
Oven Removal / Partial Removal.)
2. Open the oven door.
3. Remove the single Phillips-head screw that
holds the door switch access cover to the outer
cover.
4. Disconnect the switch wiring.
Note: Each latch board is held in place with 2
Phillips-head screws. The screws are recessed
from the top of the outer cover. Access holes are
provided. A magnetic screwdriver is necessary to
capture these screws.
5. Remove the 2 Phillips-head screws that attach
the latch board to the oven chassis.
6. Remove the door switches from the latch board.
– 40 –