Clarion NP401 Owner's Manual & Installation Manual page 32

5.1.2.3 Entering an address without knowing the
district/suburb
Long roads can run across several districts or
suburbs. You may not know what particular house
number is located where. In this case, follow the
instructions below:
The procedure is explained starting from the
Navigation menu.
1. Tap the following buttons:
mode), or , (Advanced mode).
2. By default, Clarion Mobile Map proposes the
country/state and city where you are. If needed,
tap the button with the name of the country/
state, and select a different one from the list.
3. If needed, change the city:
• To select the city from the list of recently used
ones, tap the button.
• To enter a new city:
a) Tap the button with the name of the city, or
if you have changed the country/state, tap
.
b) Start entering the city name on the keyboard.
c) Get to the list of search results:
• After entering a couple of characters, the
names that match the string appear in a list.
• Tap
before it appears automatically.
d) Select the city from the list.
4. Enter the street name:
a) Tap .
32 NP401
(Simple
to open the list of results
b) Start entering the street name on the
keyboard.
c) Get to the list of results:
• After entering a couple of characters, the
names that match the string appear in a list.
• Tap to open the list of results
before it appears automatically.
d) Instead of selecting one of the streets, tap
.
5. nter the house number:
a) Tap
b) Enter the house number on the keyboard. (To
enter letters, tap
alphabetic keyboard layout. To enter symbols,
tap ).
c) Tap to finish entering the address.
6. A list appears with the matching addresses.
Tap the desired one.
7. The map appears with the selected point in
the middle. Tap
(Advanced mode) from the Cursor
menu. The route is then automatically calculated,
and you can start navigating.
5.1.2.4 Selecting an intersection as the destination
The procedure is explained starting from the
Navigation menu.
1. Tap the following buttons:
mode), or , (Advanced mode).
.
and select an
(Simple mode) or
(Simple