Clarion VRX610 Owner's Manual & Installation Manual page 21

Problem Cause
When the TV Bad receiving condition
tuner is con-
nected, the image
gets unclear.
The TV tuner has Bad receiving condition
a double or triple
image.
The TV tuner has Presence of jamming
spots or stripes in
the image.
There are red,
green, and blue
points in the
display.
40
VRX610
Measure
A radio wave may not reach sufficiently due to
obstruction of mountains or buildings. Check it again
at a place where a radio wave can be received
properly.
It may be under the influence of radio wave reflected
by mountains or buildings. Check it again after
changing place or direction.
It may be under the influence from automobiles,
streetcar, power cable, neon sign, and so forth.
Check it again after changing place.
This is not a failure, but a phenomenon peculiar to a
liquid crystal panel (The LCD panel is produced
according to technology with very high precision.
Note that, though there are effective pixels of 99.99%
or more, pixel missing or normally lit pixels account
for 0.01%).
10. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed. Take the measures described to eliminate
the problem.
Cause
Error Display
ERROR 2 A CD is caught inside the CD deck and is
not ejected.
ERROR 3 A CD cannot be played due to scratches,
etc.
ERROR 6 A CD is loaded upside-down inside the CD
deck and does not play.
ERROR 2 A CD inside the CD changer is not loaded.
ERROR 3 A CD inside the CD changer cannot be
played due to scratches, etc.
ERROR 6 A CD inside the CD changer cannot be
played because it is loaded upside-down.
ERROR H Displayed when the temperature in the
MD changer is too high and playback has
been stopped automatically.
ERROR 2 An MD inside the MD changer is not
loaded.
ERROR 3 An MD inside the MD changer cannot be
played due to scratches, etc.
ERROR 6 An MD inside the MD changer cannot be
played because it is loaded upside-down.
Displayed when a non-recorded MD is
loaded in the MD changer.
If an error display other than the ones described above appears, press the RESET button. If the
problem persists, turn off the power and consult your store of purchase.
Measure
This is a failure of CD deck's mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
This is a failure of CD changer's mecha-
nism and consult your store of purchase.
Replace with a non-scratched, non-warped-
disc.
Eject the disc then reload it properly.
Lower the surrounding temperature and
wait for a while to cool off MD changer.
This is a failure of MD changer's mecha-
nism and consult your store of purchase.
Replace with a non-scratched, non-warped-
disc.
Eject the disc then reload it properly.
Load a pre-recorded MD in the MD
changer.
41
VRX610