Clarion VRX610 Owner's Manual & Installation Manual page 20

DSP operations
By pressing the PRESET buttons # 1 to 6 for
2 seconds or longer in the P.EQ adjusting dis-
play, the P.EQ pattern can be stored in the
USER memory.
7. To set a title of the stored USER pattern, op-
erate the JOYSTICK ¡ rightward or leftward
to select "TITLE" and press the ENT at the
center of the JOYSTICK ¡ to change into the
Title Input display.
For title inputting method, refer to the section
"Entering titles".
8. Operate the JOYSTICK ¡ rightward or left-
ward to select "MENU" and press the ENT at
the center of the JOYSTICK ¡ to change into
the AUDIO-MODE display.
38
VRX610
9. IN CASE OF DIFFICULTY
Problem
Cause
Power does not Fuse is blown.
turn on.
(No sound is
produced.) Incorrect wiring.
Nothing happens The microprocessor has
when buttons are malfunctioned due to noise,
pressed. etc.
Display is not
accurate.
DCP or main unit connectors
are dirty.
The remote
The display is not open.
controller does
not work.
Direct rays of the sun fall on
the light-receptive part of the
remote controller.
The batteries of the remote
controller unit are dead or
there is no battery in the
remote controller unit.
The image is not The parking brake is not
displayed. pulled.
The display is The brightness control is too
dark. low.
The operating condition is
not good.
The headlight of the vehicle
is lit.
The color of the The color is not adjusted
display is light or adequately.
a shade of color
is not good.
When the VTR is Improper NTSC/PAL setting
connected, the
image is
disturbed.
Measure
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Turn off the power, then press the RELEASE lever
6 and remove the DCP.
Press the RESET button for about 2 seconds with
a thin rod.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
The remote controller does not work unless the
display is open.
When direct rays of the sun fall on the light-
receptive part of the remote controller, it may not
work.
Check the batteries of the remote controller unit.
Check that the parking brake is applied.
Adjust the brightness properly.
The temperature inside the vehicle may be 0˚C or
less. Set to an appropriate temperature (25˚C or
so) and check it again.
The display is made dark at night to prevent the
glare (When the headlight of the vehicle is lit in the
daytime, the display gets dark).
Check that COL and HUE are adjusted properly.
Set the NTSC/PAL properly according to the VTR.
VRX610
39