For Compound Miter Cuts - RIDGID R4231 Operator's Manual

COMPOUND MITER CUTS
To avoid serious personal injury, before
turning the saw power ON:
1.
Check to make sure saw head and blade will not make
contact with the provided work clamp or fence during
the cutting operation.
2.
Position the work clamp and fence to avoid contact with
the miter saw head.
See Figure 34.
A compound miter cut uses a combination of a miter angle
adjustment and bevel angle adjustment. Use the instructions
from "Miter Cuts" and "Bevel Cuts" to set your bevel and miter
angle before performing the operation instructions above.
NOTE:
The miter angle and bevel angle are dependent upon
each other. If you adjust one of these it will change the other.
ALWAYS check both angles after making any adjustments.
OPERATION
27
Figure 34