Supporting Long Workpieces; Power Switch Lock - RIDGID R4231 Operator's Manual

OPERATION

SUPPORTING LONG WORKPIECES

Additional support may be used to make the workpiece lay
A
flat on the saw table. Use the included work clamp or a
C-clamp to secure the workpiece to the miter saw table.
B
See Figure 28.
A B
Figure 28

POWER SWITCH LOCK

To prevent any unauthorized person from
operating this saw, a padlock (not included) should be installed
into the lock hole located on the power switch. See Figure 29.
Be sure padlock is fully closed and locked before leaving this
F2
saw unattended.
Safety switch indicated in Figure 29 needs to be engaged
F2
prior to operation of the machine.
ALWAYS disconnect the power supply
before installing or removing a lock onto the power switch.
Failure to do so could allow the power switch to engage by
accident, resulting in serious injury.
Figure 29
24