Unpacking; Removing Contents From Packing; Packaged Contents List - RIDGID R4231 Operator's Manual

REMOVING CONTENTS FROM PACKAGING
Check shipping carton and machine for damage before unpacking. Carefully remove packaging materials, parts
and machine from shipping carton. ALWAYS check for and remove protective shipping materials around motor and moving parts.
Lay out all parts on a clean work surface.
• Compare package contents to Component Parts List and Hardware Package List prior to assembly to make sure all items are
present. Carefully inspect parts to make sure no damage occurred during shipping. If any parts are missing, damaged or pre-
assembled, DO NOT assemble. Instead, call RIDGID
If any parts are missing, DO NOT attempt to plug in the power cord and turn the power on. The saw should ONLY be
•
energized after all parts have been located and correctly assembled.
• This saw is packaged and shipped with saw head secured in the down position. Please see "Preparing Your Saw for Transport"
section of this manual for instructions on how to use the saw head lock pin. Once the saw head is in the upright position,
remove Styrofoam packaging block and discard.
PC1

PACKAGED CONTENTS LIST

RIDGID R4231
PC1
®
T30 Torx/Blade Wrench
PC2
(on machine) *see Figure 1 for storage location
Work Clamp
PC3

UNPACKING

Customer Service at (toll free) 1-888-359-4778.
®
PC2
PC3
Figure 3
Dust Bag
PC4
2 1/2 inch Dust Port Adapter
PC5
11
PC4
PC5