Installing The Software - Canon DR-7080C Instruction Manual

Installing the Software

This section describes how to install the ISIS/TWAIN driver, CapturePerfect, and
Job Registration Tool that are used when operating the scanner.
CapturePerfect and the Job Registration Tool use the TWAIN Driver. Install the
software in the order of the ISIS/TWAIN Driver, CapturePerfect, and then the Job
Registration Tool.
G The Job function is not supported on a computer that is running Windows NT. If you
want to use the Job function, run the scanner with a computer running a supported
Important
operating system other than Windows NT.
G If another ISIS compatible driver is already installed on the computer, be sure to
make a backup of the following file. The content of this file may be overwritten when
the ISIS/TWAIN driver is installed.
C:\Windows\PixTran\*.*
C:\Windows\System\pix*.dll
G The names of the "\Windows" and "\Windows\System" folders are different, depending
on which Windows operating system you are using. The names of the above folders
are representative and should be replaced by the name of the folder used in your
operating system.
1
Turn ON your computer and start Windows.
Be sure to log on as an administrator if your system is Windows NT 4.0 Workstation,
Windows 2000 Professional, or Windows XP.
Important
2
Insert the setup disc into the CD-ROM drive.
This manual assumes that "D" is assigned to your CD-ROM drive.
3.2 Installing the Software
37