Setting The Event Function - Canon DR-7080C Instruction Manual

Chapter 4 Using the Scanner
5
Place the document onto the scanner.
See "Placing Documents onto the Scanner," on page 48 for information about placing
documents onto the scanner.
Important
6
Press the [Start] key.
The image file is forwarded in accordance with the selected job.
7
When scanning of the document is complete, press the [Stop] key
to exit the Job Mode.
If you cannot get the Job Mode to operate correctly, see "Troubleshooting," on page 86.
Note
N Setting the Event Function
The Job function does not function when [DR7080C Job Tool] has not been
specified in the scanner's Event function. Before using the Job function, set the
scanner's event according to the following procedure.
1
Click the [Start] button, then click [Settings] - [Control Panel].
60