Document Feeding And Scanning; Scan Procedure - Canon DR-7080C Instruction Manual

Chapter 4 Using the Scanner
This section describes the various different document feeding modes that are
available, and the basic steps to use each mode for scanning.
I Avoid wearing loose fitting clothing, dangling jewelry, long ties, or even long hair that
could become entangled with moving parts, especially the rollers that feed the paper.
CAUTION
If such objects become entangled, immediately disconnect the power plug from the
power outlet to stop the scanner.
I Check the stack and remove all clips, staples, pins, or any other type of metal or
plastic fastener. They may damage the document, cause a paper jam, or scanner
malfunction.

Scan Procedure

The ISIS/TWAIN driver "Feeding Option" setting allows you to select from among
the three feeding modes described below. The procedure you should use
depends on the currently selected feeding mode.
G Standard Feeding (See p. 55.)
With this mode, you start and stop scanning from an application on your
computer. After placing the document onto the scanner, instruct the scanner
from your computer to start scanning.
G Panel Feeding (See p. 56.)
Panel feeding comes in handy when using the feeder for continuous scanning,
for scanning page-by-page from a book, etc. After placing the document page
onto the scanner, press the scanner's [Start] key to start scanning.
When scanning is complete, place the next document page onto the scanner,
and then press the [Start] key again.
G Automatic Feeding (See p. 57.)
Use this mode for scanning a stack of document pages with the feeder. The
scanner will start scanning automatically when it detects a document in the
document feeder tray. Scanning stops when the document feeder tray is empty.
Loading the next document into the document feeder tray restarts scanning.
54

Document Feeding and Scanning