Throttle Cable; Choke Cable; Clutch Cable - Suzuki LT-R450K6 Setup Manual

THROTTLE CABLE

Check the throttle cable play at the throttle lever end.
Throttle cable play: 3.0–5.0 mm
If adjustment is necessary, carry out the procedure
below:
1. Loosen the throttle cable adjuster lock nut A.
2. Turn the adjuster B in or out until the correct play.
3. Tighten the lock nut A while holding the adjuster B.
Place the rubber boot C.
After the adjustment is completed, check that
handlebar movement does not raise the engine
idle speed and that the throttle grip returns
smoothly and automatically.

CHOKE CABLE

Check the free play in the choke cable.
Choke cable play: 0.5–1.0 mm
If the cable needs adjusting, use the following proce-
dure.
1. Loosen the lock nut B and turn the adjuster A to
obtain the correct free play in the choke cable.
2. Move the cable back and forth firmly to ensure that
the correct amount of free play is available and that
the cable housing is properly seated in the adjuster
A.
3. Tighten the lock nut B, and set the rubber boot C
to correct position.

CLUTCH CABLE

Check the clutch lever play at the clutch lever end
when the lever is lightly pulled in towards the grip.
Clutch lever play: 10–15 mm
NOTE:
Minor adjustments can now be made with the
clutch lever adjuster D.
If adjustment is necessary, carry out the procedure
below:
1. Turn in the clutch lever adjuster D.
2. Loosen the cable adjuster lock nut A.
3. Turn the cable adjuster B to obtain the correct play.
4. Tighten the lock nut A.
5. Place the rubber boot C.
18