Changing The Fuse; About Gps Satellite Signals; Mounting On Your Dashboard - Garmin Zumo 660 Owner's Manual

Appendix
• Do not leave your zūmo in direct
sunlight. Avoid prolonged exposure to
excessive heat.

Changing the Fuse

CauTion: When replacing the fuse, do
not lose any of the small pieces, and ensure
they are put back in the proper place.
If your unit does not charge in your vehicle,
you may need to replace the fuse located at
the tip of the automotive adapter.
1. Unscrew the black, round end piece, and
remove it.
2. Remove the fuse (glass and silver
cylinder), and replace with a 3A fast‑blow
fuse.
3. Ensure that the silver tip
is placed in the black end
piece. Screw on the black
end piece.
40

About GPS Satellite Signals

Your zūmo must acquire GPS (Global
Positioning System) satellite signals to
navigate. If you are indoors, near tall
buildings or trees, or in a parking garage,
your zūmo cannot acquire satellites. Go
outside to an area free from tall obstructions
to use your zūmo.
When your zūmo has acquired satellite
signals, the signal strength bars on the Menu
page are green
signals, the bars turn red or clear
For more information about GPS, go to
www.garmin.com/aboutGPS.
End End
piece piece
Silver tip Silver tip
Fuse Fuse
Mounting on Your
Dashboard
Use the enclosed mounting disk to mount
your unit to the dashboard and comply with
certain state regulations.
1. Clean and dry the dashboard where you
. When it loses satellite
2. Remove the backing from the adhesive
.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover from the
5. Place the suction cup mount on top of
CauTion: The permanent mounting
adhesive is extremely difficult to remove
after it is installed.
are placing the disk.
on the bottom of the disk.
top of the disk.
the disk. Flip the lever down (toward the
disk).
zūmo 600 Series Owner's Manual