Sanyo PDG-DWL100 Owner's Manual page 30

Volume:

■
■
Lamp Counter Reset
Reset the lamp life hour after replacing a new lamp.
Security Settings
Security Settings:

■ On: Choose "On" to enable security verification when turning on
the projector.
■ Off: Choose "Off" to be able to switch on the projector without
password verification.
Change Password:

■ First Time:
1. Press "ENTER" to set the password.
2. Use number buttons to enter default password and then press
3. Use number buttons on the remote to enter your new pass-
4. Enter new password again and press "ENTER" to confirm.
■ Change Password:
Password default
1. Press "ENTER" to input old password.
value is "1234" (first
time).
2. Use number buttons to enter current password and then press
If you input incorrect
password 3 times, the
3. Enter new password (4 digits in length) using the number but-
projector will automati-
cally shut itself down
4. Enter new password again and press "ENTER" to confirm.
and enter into standby
mode.
Factory Default
Return the adjustments and settings to the factory default values.
(except for lamp counter and security setting)
All manuals and user guides at all-guides.com
User Controls
Press the to decrease the volume.
Press the to increase the volume.
"ENTER" to confirm.
word and then press "ENTER" to confirm. (The password has
to be 4 digits.)
"ENTER" to confirm.
tons on the remote, then press "ENTER" to confirm.
29
English
English