Sanyo PDG-DWL100 Owner's Manual page 11

Introduction
5
To quick change
6
remote control code,
press "MENU" and
"IMAGE" buttons
7
about 10 seconds at the
same time.
8
9
The bottom side of OSD
menu might be out
10
of display when user
adjusts keystone value,
under the status of low
11
resolution signal input
and different aspect
ratio setting. To solve
12
this problem, please
adjust keystone value
in "Aspect Ratio" of
"4:3" then switch back 13
to your desired aspect
ratio.
14
15
16
17
18
10
English
All manuals and user guides at all-guides.com
MENU Press "MENU" to launch the On-
screen display (OSD), back to the top
level of OSD for the OSD main menu
operation
IMAGE Select the Image mode from Presenta-
tion, Movie, sRGB, Bright and User.
INPUT Press "INPUT" to choose RGB,
SCART, Component, S-Video, Com-
posite and HDMI sources.
D.ZOOM - Zoom out the projector display.
KEYSTONE Adjust the image to compensate for
+/- distortion caused by tilting the projec-
tor.
LAMP CON- Select the lamp mode.
TROL Mode" function
AV-MUTE Momentarily turn off/on the audio
and video.
COMPUTER 1 Press "COMPUTER 1" to choose
Computer in 1/Component in 1 con-
nector.
COMPUTER 2 Press "COMPUTER 2" to choose
Computer in 2/Component in 2 con-
nector.
FREEZE Pause the screen image. Press again to
resume the screen image.
Four
Use
or
Directional
make adjustments to your selection.
Select Keys
ASPECT Display the "Aspect Ratio" section of
the on-screen display menu to select
the desired aspect ratio.
D.ZOOM + Zoom in the projector display.
INFORMA- Display information menu.
TION
"ECO
(refer
)
to select items or
or or