Bowflex SelectTech 2080 Service Manual page 15

4. Using a 3 mm hex wrench, loosen and remove the hardware
(indicated by arrows) that attaches the Barbell Handle to the Selection
Housing. Set the hardware safely aside for reassembly.
5.
Slide the old Selection Housing assembly out of the Barbell Handle
tube and discard.
Note: This step may require two people.
6. Installation is the reverse procedure.
NOTICE: Make sure the new Selection Housing is aligned with
the Selection Housing assembly at the other end of the
Barbell Handle. Fully tighten the hardware.
When installing the new Adjustment Knob, make sure
the Filler Insert is correctly oriented. Fully tighten the
hardware.
7.
Carefully replace the barbell assembly in the base.
NOTICE: Be sure the barbell assembly is fully seated in the base.
8.
Test the locking mechanism to make sure it is functioning correctly.
Refer to "Testing Proper Locking Mechanism Function" in this manual.
9. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
15
X6
3 mm