Bowflex SelectTech 2080 Service Manual page 12

5. Turn both Barbell adjustment knobs to 30 lbs. (13.6 kg).
Note: Setting the weight selection to 30 lbs (13.6 kg) is the most efficient
and effective way to determine the proper distance between the two
Base Shrouds.
6. Remove the Barbell from the Base. There should be 2 Weight Plates
lifted on each side of the Barbell.
If the Barbell picks up more than 2 Weight Plates on each side,
do not use the Barbell. Contact Bowflex Customer Service or
your local distributor for a replacement Barbell handle
assembly.
Put the Barbell back into the Base. When the base is adjusted to the
correct distance, there should not be any interference during the process
of removing and installing the Barbell.
Repeat this step using the Curlbar.
7. Turn both adjustment knobs to the maximum setting (80 lbs., or 120
lbs. with the 40-lb Upgrade) and remove the Barbell from the Base. All
Weight Plates should be lifted with no interference if the Base Shrouds are
spaced correctly.
8. With the Barbell and all Weight Plates removed from the Base, fully
tighten the remaining screws and ensure that both Base Shrouds are
firmly secured in position.
9. Put the Barbell back into the Base. There should not be
any interference during the process of placing or removing the
Barbell.
10. Repeat the 30-lb test in Steps 5 - 6. There should not be
any interference during the process of placing or removing the
Barbell.
If there is interference, repeat the adjustment procedure.
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
12