What Is Waas - Garmin GPSMAP 396 Pilot's Manual

Portable aviation receiver
Hide thumbs Also See for GPSMAP 396:
Table of Contents

Advertisement

A
>
L
GPS
PPENDIX
EARNING ABOUT
• Check Beacon Wiring—the DGPS setting is enabled in the
Interface sub tab on the Main Menu but no DGPS device is
detected.
• No Beacon Signal—DGPS receiver is attached, but not
transmitting RTCM data to GPS.
• Tuning Beacon—the receiver is tuning manually to a DGPS
frequency.
• Using Differential—the unit is receiving DGPS corrections.
• Scanning for Beacon—the DGPS receiver is scanning for an
available frequency.

What is WAAS?

The Wide Area Augmentation System (WAAS) is an FAA-funded
project to improve the overall integrity of the GPS signal and
increase location accuracy for users in North America.
The system is made up of satellites and approximately 25 ground
reference stations located across the United States that monitor GPS
satellite data. Two master stations, located on either coast, collect
data from the reference stations and create a GPS data correction
message.
164
According to the FAA's Web site, testing of WAAS in September
2002 confirmed an accuracy performance of 1–2 meters horizontal
and 2–3 meters vertical throughout the majority of the continental
United States and portions of Alaska.
WAAS is just one service provider that adheres to the MOPS
(Minimum Operational Performance Standard) for global Satellite
Based Augmentation Systems (SBAS). Eventually, there will
be several services of worldwide geostationary communication
satellites and ground reference stations.
All SBAS systems use the same receiver frequency; therefore, any
operational SBAS system should be capable of providing your GPS
unit with increased accuracy at any location in the world.
Currently, enabling WAAS on your Garmin GPSMAP 396 in regions
that are not supported by ground stations may not improve accuracy,
even when receiving signals from an SBAS satellite. In fact it can
degrade the accuracy to less than that provided by GPS satellites
alone. For this reason, when you enable WAAS on your Garmin
GPS receiver, the receiver automatically uses the method that
achieves the best accuracy. To enable WAAS, refer to
For more information, go to
http://gps.faa.gov/Programs/WAAS/waas.htm.
page
6.
GPSMAP 396 Pilot's Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents