Creating User Waypoints - Garmin GPS 95AVD Owner's Manual

User waypoints are only selected by the identifier that you assign.
To select a user waypoint...
· Press WPT and, if needed, the WPT softkey to display the Waypoint
Definition Page.
· If "USR", for user waypoint, is not currently displayed in the upper
corner: press the right arrow key to place the cursor on the cyclic field,
then press CLR (repeatedly) until "USR"is shown.
· Press the right arrow key to move the cursor to the right of "USR".
· Enter the identifier of the desired user waypoint using the alphanumeric
and arrow keys. Press ENT. The information for the selected user
waypoint is displayed.
You may select a reference waypoint by moving the cursor to the reference
waypoint identifier field and entering the desired waypoint identifier (airport,
VOR, NDB, intersection or user waypoint).

3.7 CREATING USER WAYPOINTS

When a waypoint identifier has been entered that does not exist in memory
the GPS 95 will assume you wish to create a new waypoint. You may create
a new waypoint using one of two methods: direct position entry (latitude/
longitude or grid system) or relative to an existing waypoint.
In order to create a waypoint by direct position entry the coordinates for the
new waypoint must be known and entered directly into the unit.
To enter the waypoint position directly...
· With the Waypoint Definition Page displayed (and user waypoint
information shown), press the right arrow until the cursor is over the
waypoint identifier field.
3-10