Maintenance - Beckett GENISYS 7565 Quick Start Manual

Resetting From Restricted or Hard Lockout
Before starting or resetting the
control from restricted lockout state,
troubleshoot the heating system for
the root cause(s) of the lockout.
•
Make necessary repairs or adjustment
to ensure a safe start condition.
•
Ensure that the appliance is free of
oil and oil vapors before starting or
resetting the burner.
◦
If the control continues to lock out without a
satisfied call for heat, or fails the motor relay
check, the control enters Hard (restricted)
Lockout in order to limit accumulation of
unburned oil in the combustion chamber.
◦
To reset, hold the ACTION button down for 15
seconds until the SYS light is no longer red.
◦
Always verify the control functions according
to all specifications before leaving the
installation site.
◦
Replace the control if it does not operate as
specified.
120v GeniSys Control Installation and Operation Manual
Fire, Smoke &
Fuel Leak Hazard
Disable Function
◦
Any time the burner is running, press and
hold the ACTION button to disable the
burner. The burner will remain off as long as
the button is held.

Maintenance

Oil heating systems require annual service
performed by a qualified, professional service
agency. The 7565 primary control should be
inspected during this service routine according
to the following checklist:
□
NOTE: The 7565 control has no
serviceable internal parts. Do not attempt
to remove cover.
□
Inspect the exterior of the control.
Replace the control if there is any sign of
impact damage, water or corrosion.
□
Use a multimeter to test the line voltage
at control L1 and L2. It should be 102 -
132 Vac.
□
Inspect all external wiring for secure
connections and verify insulation integrity.
□
Verify the control lockout and
operation sequence (Refer to "Check
Safety Features" of the Startup/
Checkout section).
□
Observe a full operating cycle to prove
the sequence and timings are correct.
□
Replace any control that does not meet
listed specifications with an equivalent
replacement unit.
9