GOVERNOR
1
2
3
4
b
5
6
7
2
8
9
10
3
4.
INSTALLING THE THROTTLE LEVER ASSEMBLY
(Equipped models)
1.
1
a
ADJUSTING THE GOVERNOR
1.
Adjustment steps:
2
1
Adjust:
• Governor
(Refer to "ADJUSTING THE GOVERNOR" on page
3-30)
Tighten:
• Throttle lever assembly bolt
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Tighten the throttle lever assembly bolt "1" while
pushing the hole "a" for installation of the throttle
lever assembly against the crankcase "b".
b. Tighten the throttle lever assembly bolt "2".
c. Tighten the throttle lever assembly bolts "1" and "2"
to the specified torque.
Throttle lever assembly bolt:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Adjust:
• Governor
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen the governor arm bolt "1".
b. Turn the governor arm "2" clockwise until it stops.
c. Turn the governor fork "3" clockwise until it stops.
d. Tighten the governor arm bolt "1".
Governor arm bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3-30