Checking The Spark Plug Cap Resistance; Checking The Air Gap - Yamaha MZ360 Service Manual

ELECTRICAL COMPONENTS
1
2
3
4
5
6
7
2
8
1
9
10

CHECKING THE SPARK PLUG CAP RESISTANCE

1.
Remove:
• Spark plug cap
2.
Check:
• Spark plug cap resistance
Out of specification  Replace the spark plug cap.
Spark plug cap resistance:
3.75–6.25 k
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the spark plug cap from the high tension
cord.
b. Connect the digital circuit tester () to the spark
plug cap as shown.
Digital circuit tester (CD732):
90890-03243
Model 88 Multimeter with tachometer:
YU-A1927
• Positive tester probe 
Spark plug side "1"
• Negative tester probe 
High tension cord side "2"
c. Measure the spark plug cap resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲

CHECKING THE AIR GAP

1.
Check:
• Thickness between the magnet rotor and TCI unit
Out of specification  Perform the TCI unit adjust-
ment steps.
(Refer to "INSTALLING THE TCI UNIT" on page
3-20)
TCI unit air gap:
0.4–0.6 mm (0.0157–0.0236 in)
CHECKING THE IGNITION COIL (TCI UNIT,
PRIMARY) RESISTANCE
1.
Check:
• Primary coil resistance
Out of specification  Replace.
5-11