Roadtrek CS Adventurous Owner's Manual page 46

Utilities
City water valve access - loosen the
screws (locations indicated by red
arrows) and remove the radiator cover
• • Close all interior faucets.
• • Flush old water and any contaminants out of the water supply faucet.
• • Connect your fresh water hose to the faucet.
• • Attach your pressure regulator to the Roadtrek's city water connection.
• • Attach a fresh water hose to the the pressure regulator.
• • Slowly open the faucet of the city water source.
• • The city water connection by-passes the water pump and fresh water tank. Therefore, the use of these items is not
necessary when connected directly to an external water source.
To disconnect the city water connection:
• • Turn off the external water source.
• • Open a faucet to relieve the pressure in the system. Failure to do so will not damage your vehicle, but may result in an
unexpected shower. The outside shower faucet next to the city water connection is a convenient place to do this.
• • Make sure the city tank fill valve is closed (handle vertical and across the water line).
• • Remove the hose from the city water connection, and replace the cap on the fill connection.
City water valve (red arrow) in closed
position - handle across line
43
© 2015 by Roadtrek, Inc.