Roadtrek CS Adventurous Owner's Manual page 20

Interior Living Space
17
Always return the seats to the forward-facing position when driving - the seats will lock in place as you swivel them
to face forward.
To create a front lounge area, first ensure that the seats are fully upright by loosening the recline adjustment and bringing
the backs of the seats forward. Do not attempt to pivot a reclined seat. Use the fore-and-aft adjustment while pivoting the
seats to allow the sides of the chairs to clear the armrests on the vehicle doors and other obstructions. Do not force the seats
around. Swiveling the driver's seat may require you to loosen the tilt steering wheel adjustment and move the steering wheel
as far forward and up as possible. Opening the driver's and passenger front door will also facilitate swiveling the front seats.
The third seat will swivel easily once it is brought forward from the bathroom wall.
Lights
The circular ceiling lights are all individually controlled, and are
tap lights - to turn them off or on, press on the lens area. All
lights are 12 volt lights, so the battery disconnect switch must
be on for any of the lights to work. They work whether the
inverter is off or on.
The lights have LED bulbs, which use less power and are cooler
than typical incandescent bulbs.
Blinds
The blinds on the side and back windows of the CS Adventurous
Roadtrek have a partially opaque, "shade" window covering, and
also a completely opaque, "dark" window covering. Pull the
blinds down for the "shade" window covering, and then pull the
bar above this first section of blind material down to bring the
"dark" section over the windows to sleep or for privacy at night. Tap light
The blind above the galley area is an easy-to-clean metal blind
which will also close completely for privacy.
© 2015 by Roadtrek, Inc.